mcpro24fpsProfessional Video Camera for Android

Sony Xperia

Rules "for all Xperia" apply to any Sony phone, including Xperia 10 and Xperia L, which have no entries of their own.

All Xperia

  • White balance. Manual white balance is available only on cameras with the full hardware level. Leaving manual white balance outside of recording reopens the whole camera: after manual mode, "Auto" gave a cold image. Manual mode cannot be left during recording.
  • Frame rates. 48 and 50 fps are always marked as non-native: the camera runs at 60, and the app drops frames. An exact frame rate range is requested from the camera only when the camera itself has declared such a range.
  • 120 fps. On all Xperia 1 and 5 models and on the PRO-I, 120 fps goes through a high-speed session, as in the stock app: the preview uses the largest high-speed size up to 1920 wide. Tested on Xperia 5, 5 II, 5 III and 5 IV: exactly 120.0 fps.
  • Human and animal eye autofocus. If the camera declares this capability (in practice Xperia 1 and 5 of all generations), with "Face focus" turned on in auto mode the app asks the camera to track eyes. The eye frame is drawn by the camera itself in the preview; it does not get into the file.
  • Distortion correction. The menu is taken from Sony vendor modes, not from the standard ones. Tested on the 5 IV.
  • Stabilization. Optical stabilization is turned on only where both the camera and the module the request goes to declare it.
  • RAW. In RAW the camera module cannot be switched: the module buttons are hidden, focal length and zoom are locked. RAW recording starts on the default module. Switching modules in RAW crashed the camera service on the 5 III.
  • Vignette correction in RAW. Sony's own vignette correction in RAW works poorly, so the app turns it off and applies its own, which requires calibration. The first time the RAW codec is turned on with "Vignette correction" enabled, the message "Calibrating vignette correction, please wait a few seconds" stays on screen for a few seconds, the preview may get lighter or darker, and recording cannot be started during that time. The measurement is done once for each camera and is repeated after a firmware update. If the scene is unsuitable (too dark, overexposed, the light changed during the measurement), the measurement is cancelled and will start again the next time the camera is opened. An evenly lit scene without overexposed areas works best. Our map goes into DNG as a GainMap, into .mcpro as a separate block, and in the "baked-in" variant it is applied to the pixels; the preview is corrected the same way. In auto exposure the image is then taken slightly darker, by about 0.4 EV. In high-speed recording the measurement is not started. Tested on Xperia 5 IV, main camera.
  • Codec. On Android 12 and older, special timestamp and NAL unit length parameters for 10-bit are passed to the codec.
  • 10-bit does not work when recording through the GPU: the camera does not declare 10-bit for this path, and the file comes out 8-bit.
  • Shutter speeds longer than one second are not available in video: the camera crashes with them.

Xperia XZ Premium, XZ1, XZ1 Compact

  • Frame rates and sizes. At 24, 25 and 60 fps no frame rate range is requested from the camera. 30 fps beyond what is reported on the main camera, GPU only: 2880×1620 and 3040×1710.
  • Session. Above 30 fps or with stabilization, a vendor camera mode is turned on.
  • Stabilization. On the main camera "off" and "on" are forcibly available. In "video" mode stabilization is provided by the vendor mode itself, not by the standard parameter.
  • 10-bit is not allowed.
  • The shutter speed is duplicated into a Sony vendor hint, otherwise the camera does not hold it.

Xperia XZ2, XZ2 Premium, XZ2 Compact, XZ3

  • 10-bit is allowed. Limit: 24 fps at 3264×2448. In 10-bit at 24 fps the camera needs the 30 range, otherwise it does not start.
  • Session. In 10-bit a vendor camera mode is turned on.
  • On Android 11 and older, 10-bit HEVC is recorded with the HDR10 profile.

Xperia 1, Xperia 1 Pro, Xperia 5 (first generation)

  • Cameras. Only cameras 0 to 4 are enumerated. The main camera is opened as a logical camera with optical zoom between modules.
  • Frame rates. 60 fps on the main camera only in auto exposure: 1920×1080 directly and 2560×1440 through the GPU. The same on cameras 3 and 4. 30 fps through the GPU as on the XZ Premium.
  • 10-bit is allowed.
  • RAW. On the first-generation Xperia 5, RAW is closed on the logical camera: the camera service crashed in most starts. RAW is available on the physical modules; you have to choose the module yourself. If the camera service crashes, the app reopens it by itself, up to two attempts.

Xperia 1 II, Xperia 5 II

  • Cameras. Above 30 fps (on Android 11 and newer) or above 60 fps, the main camera is opened as actual camera 2. Modules are switched according to the list of focal lengths the camera itself reports; the list applies up to 30 fps or up to 1080p60. On start the zoom mode is reset to the base module.
  • Frame rates. 60 fps on the main camera: 1920×1080, 2520×1080, 3840×1644 in any exposure mode, 2560×1440 through the GPU, 3840×2160 without GPU, 1680×720 only in auto. A similar set on camera 2. 120 fps without GPU: 1280×720, 1680×720, 2520×1080, 3840×1644, 3840×2160 (on the 1 II only with Android 11). 1920×1080 at 120 does not work on the 1 II, and on the 5 II works only in 8-bit. 48 and 50 fps on the 5 II go as a copy of 60.
  • Focus. Above 60 fps, autofocus is temporarily switched to "tap" mode and back: otherwise the camera crashed. The far limit of manual focus is set manually.
  • 10-bit. Limit 120 fps at 3840×2160. HDR item in the menu.
  • Noise reduction. Multi-frame noise reduction is turned on through a Sony vendor parameter.
  • RAW. On the 5 II, RAW is closed on the logical camera, as on the first-generation Xperia 5; on the 1 II it is open. On the 5 II the frame's module for calibration has to be calculated: the camera reports the same module regardless of zoom.

Xperia 1 III, Xperia 5 III

  • Everything said about the 1 II and 5 II.
  • The flash is forcibly considered available on the main camera.
  • Codec. For AVC the Qualcomm encoder is tried first, not the system default. Above 60 fps a vendor frame rendering mode is turned on.
  • The frame duration at 120 fps is set slightly longer than on the others: the camera asks for it.
  • RAW. On the 5 III, RAW is closed on the logical camera: the camera service crashed in most starts; on the physical module it works. On the 1 III it is open.
  • Known limitation. 10-bit at 1920×1080 at 120 fps is not recorded on the 5 III: both camera streams are 8-bit, and Sony's stock app does not record HLG in this mode either.

Xperia PRO-I

  • Behaviour as on the 1 II and 5 II: actual camera 2 above 30 fps, modules by focal length, autofocus above 60 fps, 120 fps without GPU, 10-bit limit 120 fps at 3840×2160.
  • The difference is in clipping handling: the correction is off by default, as on newer models.

Xperia 1 IV, Xperia 5 IV

  • Cameras. Visible camera 0 is always opened as actual camera 2, and visible camera 2 as actual camera 0. Modules are switched by zoom, not by focal length. The zoom steps are model-specific: 1 IV on the main camera minimum, 1×, 3.40×, 4.82×, on camera 2 from 1× to 5×; 5 IV minimum, 1×, 2.34×.
  • Vendor settings. Power saving, super resolution zoom and skin smoothing are turned off, the sensitivity restriction is removed, the minimum ISO and maximum shutter speed are set. Fusion mode between modules is off.
  • Frame rates. 50 fps in manual exposure on the main camera: 13 sizes from 720×720 to 3840×2160, plus 4032×1728 and 3840×1644; on camera 2 only 1920×1080. 48 fps as 50. 10-bit limit 120 fps at 4096×3072.
  • 10-bit and HDR. The file is tagged BT.2020 with HLG if the camera has not set its own profile. Multi-frame HDR appears in the HDR menu.
  • Codec. 10-bit HEVC is recorded with the minimum profile level.
  • Stabilization. Optical only where the module declares it.
  • RAW. The frame's module for calibration is calculated by the app: the camera reports module 2 at any zoom. RAW on the logical camera on the 5 IV works and is not closed.
  • Known limitations. 4K120 is a heavy mode on Sony: long recording overheats the sensor, and after many camera openings the firmware starts dropping frames until a reboot. Camera 2 on the 5 IV does not work at 1080p120: it has a high-speed mode only for 720p, and Sony's stock app does not use it for 120 either. 4K120 HLG with a 4K preview gives dropped frames, so the high-speed mode preview is no wider than 1920. The 5 IV ultra-wide in 16:9 is straightened by the firmware; the interface does not show this. On a hot 5 IV at 120 fps frames can be lost; this is the phone's thermal protection.

Xperia 1 V, Xperia 5 V

  • As 1 IV and 5 IV: actual camera 2, the vendor settings package, minimum HEVC level, BT.2020 with HLG, multi-frame HDR.
  • Zoom steps. 1 V: minimum, 1×, 3.68×, 5.22×. 5 V: minimum, 1×, 2×, 5×.
  • Frame rates. 50 fps on the main camera in any exposure mode: 11 sizes up to 3840×2160. 48 as 50. 10-bit limit 120 fps at 3840×2160.

Xperia 1 VI

  • As 1 V, except for one vendor parameter: "case" mode is not set on the 1 VI, as the camera dropped frames with it.
  • Zoom steps: minimum, 1×, 3.68×, 6.80×.
  • Frame rates. 60 fps up to 4096×3072 on the main camera and camera 2. 50 is a copy of 60, 48 as 50. 120 fps without GPU from 1280×720 to 3840×2160. 10-bit limit 120 fps at 4096×3072.

Xperia 1 VII, Xperia 1 VIII

  • They have no frame rate table of their own: only the general processor rules (Snapdragon 8 Gen 3 and newer) and the family's common vendor settings package, as on the 1 IV and newer, apply.